Click on the car model to check how to assembly the emulator in your car
• Audi A3 8P Hatchback/Sportback (2003-2012)
• Audi A4 B7 Saloon/Sedan & Avant (2004-2007)
• Audi A4 B8 Saloon/Sedan & Avant (2007–2015)
Assembly instruction for following cars:
• Audi A3 8P Hatchback/Sportback (2003-2012)
• Audi A4 B7 Saloon/Sedan & Avant (2004-2007)
• Audi A4 B8 Saloon/Sedan & Avant (2007–2015)
Take a look under the passenger seat, find a blue connector with 2 black wires and disconnect it from the car.
Cut the wires about 10 cm from the connector and take the connector. You need to connect the connector's wires with the emulator's wires.
With the emulator we have included 2 small fast connectors (check the photo below) to connect emulator's wires with the seat mat's wires. At the bottom side there are 2 holes were you need to insert the wires. At the top side there is an orange button which you need to push in after succesful installation of the emulator in order to lock the wires in the connector and prevent them from getting out from the fast connector.
Take the first fast conector and insert one black wire of the emulator and one black wire of the seat mat connector. Then take the second fast connector and insert the second emulator's wire and wire of the seat mat connector. DO NOT push the orange locks on the fast connectors yet.
Connect the blue connector with the emulator to your car. Be sure that the wires did not go out from the fast connectors. Connect the OBD diagnostic scanner and clear the old fault code of defective seat mat. If the old fault code of defective seat mat and the SRS/Airbag warning disappears then you can push in the orange buttons on the fast connectors to lock the wires. If the fault code re-appears after clearing then take out both emulator's wires from the fast connectors and insert them into opposite sides. For example, if the wire was in the left fast connector then put it in the right fast conenctor, and wire from the right fast connector insert into left fast connector (switch sides). Then clear the fault code again.